Mold remediation referrals for Philadelphia & nearby townsCall: (215) 774-2847
(215) 774-2847

Mold Remediation in Philadelphia, PA

moldremediationphiladelphia.net

Get connected with an independent Philadelphia mold remediation company that can find the moisture source and clean up the growth.

Mold in a Philadelphia basement, wall or attic?
Call now to be connected with a local mold remediation company in Philadelphia.
(215) 774-2847

Mold remediation is the cleanup of mold growth plus the fix for whatever keeps the area damp. In Philadelphia it usually starts in a rowhouse basement, behind a party wall or under a roof leak. Call the number on this page to be connected with a local mold company in Philadelphia.

Remediation worker treating mold on a brick and stone basement wall inside plastic containment, mold remediation in Philadelphia, PA

What mold remediation involves

Remediation means removing or cleaning mold-damaged material and correcting the moisture problem behind it. Philadelphia companies typically set up containment, run air filtration, remove porous material such as soaked drywall or insulation, clean the framing, and dry the space. EPA says the key is to dry water-damaged areas within 24-48 hours, and that biocides such as bleach are not recommended as a routine part of cleanup.

When a Philadelphia home needs it

EPA's guide says a homeowner can usually handle an area smaller than about 10 square feet. The Pennsylvania Department of Health says to hire a contractor if the area is larger, or if someone in the home has asthma, COPD, is pregnant or has other health issues; talk with your doctor about your own situation. Wet, finished basements, rowhouse party walls and flat roofs that leak tend to produce the larger jobs.

Call now to be connected with a local mold remediation company in Philadelphia.
(215) 774-2847
Remediation worker in a respirator cutting out moldy drywall behind plastic sheeting, mold remediation in Philadelphia, PA

What it costs

One Philadelphia cost guide puts mold remediation at roughly $13 to $25 per square foot, or about $1,300 to $2,500 for a 100 square foot project. National figures from HomeGuide run about $500 to $1,500 for a small area of 10 to 100 square feet and $15,000 to $30,000 for a whole home. Scope, access and how much material has to come out move the price most.

Pennsylvania checks before you hire

  • Pennsylvania has no state mold license. The Department of Health fact sheet says there are no federal or state regulations about mold, so ask for references and a written scope instead.
  • Anyone doing home improvement work on a private home must register with the Attorney General (small-volume exemptions apply). The "PA" registration number should be on the contract, and work over $500 needs a written contract with a three-day right to cancel.
  • Inside the city, the Department of Licenses and Inspections (L&I) says businesses doing construction or repair work need a City contractor license, with an exemption for work only on one- or two-family homes, which still need state registration.
  • L&I issues building permits; replacing drywall over existing wall surfaces in a one- or two-family home needs no permit, but larger structural repairs can.

If you are across the river in New Jersey or in Delaware, the rules differ, and a company there will follow its own state's registration requirements.

The Philadelphia housing angle

Brick rowhouses and twins share walls, so a leak next door can surface in your basement. Old galvanized and cast-iron plumbing, damp stone foundations and summer humidity all feed repeat growth. A good remediation plan names the water source, not just the stain.

Mold Remediation questions from Philadelphia homeowners

How much does mold remediation cost in Philadelphia?
One Philadelphia cost guide lists about $13 to $25 per square foot, or roughly $1,300 to $2,500 for a 100 square foot project. National guides give wider ranges. A written scope after an on-site look is the only reliable number.
Does Pennsylvania license mold remediation companies?
No. The Pennsylvania Department of Health says there are no federal or state regulations about mold. Companies doing home improvement work should hold Attorney General registration, and city work may involve a Philadelphia contractor license.
Can I clean mold myself?
EPA says a homeowner can usually handle an area under about 10 square feet. The state health department advises hiring a contractor for larger areas or if anyone at home has asthma, COPD or other health issues.
Do I need a permit for mold cleanup in Philadelphia?
Ordinary maintenance generally needs none, and L&I says drywall over existing surfaces in a one- or two-family home needs no permit. Bigger structural repairs may, so ask your company what applies.

Related mold services in Philadelphia

Mold Remediation in nearby cities and towns

Bucks County

Montgomery County

Delaware County

Chester County

Camden County

Burlington County

Gloucester County

Mercer County

Hunterdon County

New Castle County

Call now to be connected with a local mold remediation company in Philadelphia.
(215) 774-2847

Last updated:

☎ Call (215) 774-2847