Spraying bleach or painting over a stain does not fix mold, and EPA does not generally recommend biocides for routine cleanup. Removing the growth and the dampness is what counts. Call the number on this page to be connected with a local mold company in Jenkintown.

Mold you cannot see
Growth likes to hide behind cabinets, under vinyl flooring, above ceiling tiles and inside walls that carry plumbing. Clues include cupped floorboards, a lingering odor, or a stain that creeps outward from one point and darkens in muggy weather. Opening a small inspection hole sometimes settles the question quickly.
Rowhouses and twins
Brick party walls let a neighbor's leak travel next door, and flat roofs pond water after summer thunderstorms. Basement walls in these homes are often masonry that wicks groundwater, so mold can show up on finished surfaces built over damp brick or stone. Basements and the ground floor tend to take the worst of it.

Why two quotes can differ
One company may plan to remove a whole wall while another cleans framing in place. Containment methods, equipment and drying time also vary. A written scope that spells out what comes out and what stays makes quotes easier to compare fairly. Side-by-side scopes beat side-by-side totals.
Local details for Jenkintown
Pennsylvania's Department of Health says there are no federal or state regulations about mold, so no state mold license exists to look up. What you can check is the company's home improvement contractor registration with the Pennsylvania Attorney General.
Keep the inspection report, the scope of work and any clearance results together; buyers, landlords and insurers often ask for them later.
Rebuild work after the mold comes out, such as new drywall or framing, may need a permit; the township or borough building office for your address is where to ask for Jenkintown addresses.
Water that came in from outside raises insurance questions; FEMA's flood map search shows whether the property sits in a mapped flood zone.
Companies that take calls here usually also work in Glenside, Wyncote and Elkins Park.
Typical sequence of a job
- Walk-through and written plan
- Containment of the work area
- Removal of damaged materials
- HEPA vacuuming and cleaning
- Drying and dehumidifying
- Final check
Skipped steps are a red flag.
Ask who signs off on each stage and how the area is checked before walls close.
Do not paint over it
Primer or paint on a moldy surface hides the stain but leaves the growth underneath. It also makes later inspection harder. Fix the leak, remove or clean the affected material, and paint only after the area is fully dry. Inspect the area with a flashlight before repainting anything.
Mold Remediation questions in Jenkintown
What is mold remediation?
What does a company do with the removed material?
Should I stay in the house during the work?
How do I choose between companies?
More mold services in Jenkintown
Mold Remediation nearby
Helpful guides
Sources
Last updated: