Fix the leak first, since cleaning mold that is still being fed only brings it back. Then dry the structure and cut out soaked material. Call the number on this page to be connected with a local mold company in Upper Darby.

Signs a leak has turned into a mold problem
Look first for a musty smell that does not fade, ceiling stains with darker rings, paint that bubbles or peels, baseboards that swell and floors that cup. When two or more show up together, moisture has likely been there a while and the wall behind may be wet. Catching it at this stage keeps the repair smaller.
Flat roofs and roof seams
Many rowhouses have low-slope roofs where seams, flashing and drains wear out. A slow roof leak wets the top-floor ceiling and the insulation above it, and mold can follow long before a stain appears, especially after repeated rain. Parapet walls and roof drains deserve a look as well.

Drying versus removal
Drying saves materials that can still be saved, such as framing and subfloor. Removal covers porous items that stayed moldy, like soaked drywall, insulation and carpet pad. A company decides which is which using moisture readings, not just appearance. Photos and meter readings should support each line.
Local details for Upper Darby
Pennsylvania's Department of Health says there are no federal or state regulations about mold, so no state mold license exists to look up. What you can check is the company's home improvement contractor registration with the Pennsylvania Attorney General.
Keep the inspection report, the scope of work and any clearance results together; buyers, landlords and insurers often ask for them later.
Rebuild work after the mold comes out, such as new drywall or framing, may need a permit; the Upper Darby Township building office is where to ask for Upper Darby addresses.
Water that came in from outside raises insurance questions; FEMA's flood map search shows whether the property sits in a mapped flood zone.
Companies that take calls here usually also work in Lansdowne, Wynnewood and Drexel Hill.
The usual steps
- Confirm the water source is stopped
- Map moisture in walls, ceilings and floors
- Contain the work area
- Remove materials that stayed wet and moldy
- Dry and clean what remains
Before the next cold snap
Insulate exposed pipes in basements, garages and exterior walls, seal drafts around them, and let a faucet drip on the coldest nights. Know where your main shutoff is, so anyone in the house can stop the water in seconds. Pick one weekend each fall to do it.
Leak & Burst Pipe Mold Removal questions in Upper Darby
Can mold grow after a plumbing leak in Upper Darby?
Who removes mold after a burst pipe?
Will my insurance cover leak mold?
How long does it take mold to grow after a burst pipe?
More mold services in Upper Darby
Leak & Burst Pipe Mold Removal nearby
Helpful guides
Sources
Last updated: